Mindray DPM 1 Wartungshandbuch Seite 1

Content II Pulse oximeter Service Manual 6.3 Disinfection & Sterilization...

Introduction Pulse oximeter Service Manual 1-1 Chapter 1 Introduction 1.1 General The DPM1 Pulse Oximeter is a non-invasive, spot-check, oxygen satu

Introduction 1-2 Pulse oximeter Service Manual For Your Notes

Circuit Principle 2-1 Pulse oximeter Service Manual Chapter 2 Circuit Principle 2.1 Overview The DPM1 pulse oximeter collects SpO2 data from the

Circuit Principle Pulse oximeter Service Manual 2-2 supply for IO module and analog circuit. The voltage of them is 3.3V. S1C33209 has two crystal

Circuit Principle 2-3 Pulse oximeter Service Manual Fig 2-3 Data Storage Circuit 2.1.1.4 DAC DPM1’s analog circuit includes two DAC channels.

Circuit Principle Pulse oximeter Service Manual 2-4 2.5V voltage shift should be required. R27-C20, R20-C30 and R23-C19 form RC low pass filters to

Circuit Principle 2-5 Pulse oximeter Service Manual R85 work together to prevent the locking of the CPU. Fig 2-6 Delay Circuit Block The pow

Circuit Principle Pulse oximeter Service Manual 2-6 2.1.1.8 Serial Port Signal Voltage Level Conversion Circuit MAX202E is used for the signal vol

Circuit Principle 2-7 Pulse oximeter Service Manual 2.1.1.10 Voltage Detect DPM1 requires that the battery voltage and +7V be detected all the ti

Circuit Principle Pulse oximeter Service Manual 2-8 2.3 EMC Design The following protections are used for EMC design in DPM1: 1. Every IC has

Specifications 3-1 Pulse oximeter Service Manual Chapter 3 Specifications 3.1. General 3.1.1 Basics Product Model: DPM1 Product Name: Pulse Oxi

Specifications Pulse oximeter Service Manual 3-2 power-off has a 2 second delay. Backlight button: Switches on/off the backlight ID Confirm button:

Specifications 3-3 Pulse oximeter Service Manual 3.7. Physical Characteristics Maximum Size: 65×140×32mm (W×H×D) Maximum Weight: 130g (not incl

Specifications Pulse oximeter Service Manual 3-4 Spillage and ingress of liquid: The oximeter meets the requirements of IEC 60601-1-1, clause 44.3 an

Structure 4-1 Pulse oximeter Service Manual Chapter 4 Structure 4.1 Explosive diagram Fig 4-1 DPM1 Explosive diagram（115-001428-00） Tab

Structure Pulse oximeter Service Manual 4-2 11 047-000194-00 Equipment label(English) 1 12 0000-10-10902 Battery 4 13 0850-20-30702 Batter

Structure 4-3 Pulse oximeter Service Manual 4.2.2 Battery Maintenance 1. Use the generic 1.5V AA alkaline battery or rechargeable battery,

Structure Pulse oximeter Service Manual 4-4 FOR YOUR NOTES

Test and Prompt List Pulse oximeter Service Manual 5-1 Chapter 5 Test and Prompt List 5.1 Test Procedure 5.1.1 Connection Install batteries and co

Pulse oximeter Service Manual I Copyright Intellectual Property Statement Mindray DS USA, Inc. (hereinafter called Mindray DS) owns the intellectual

Test and Prompt List 5-2 Pulse oximeter Service Manual 5.2 Prompt List Table 5-1 Prompt Information on LCD Indications Cause Solution Low batte

Maintenance and Cleaning Pulse oximeter Service Manual 6-1 Chapter 6 Maintenance and Cleaning 6.1 Maintenance 6.1.1 Unpacking and Inspection 1.

Maintenance and Cleaning 6-2 Pulse oximeter Service Manual 5. Keep the surface of the equipment clean after cleaning. Detergents 1. Diluted

P/N: 046-000175-00 (3.0)

II Pulse oximeter Service Manual Manufacturer’s Responsibility All information contained in this manual is believed to be correct. Mindray DS shall

Pulse oximeter Service Manual III Return Policy In the event that it becomes necessary to return a unit to Mindray DS, follow the instructions belo

IV Pulse oximeter Service Manual Safety Precautions 1 . Meaning of Signal Words In this manual, the signal words WARNING and CAUTION are used regar

Pulse oximeter Service Manual V WARNING: Do not connect this system to outlets with the same circuit breakers and fuses that control current to

VI Pulse oximeter Service Manual

Content Pulse oximeter Service Manual I Content Chapter 1 Introduction....................