Mindray DPM 1 Betreibershandbuch PDF herunterladen (Seite 146)

12-2

Set Unit

You can set unit for each parameter of the following modules as required:

Module Parameter Options Defaults

IBP IBP mmHg, kPa, cmH2O mmHg

CO2 CO2 mmHg, kPa mmHg

TEMP T1, T2, TD, TB

℃, ℉ ℃

Vascular Resistance SVR/PVR DS/cm

, kPa-s/l DS/cm

NIBP NIBP mmHg, kPa mmHg

CO2 mmHg, kPa, % mmHg

GAS

mmHg, kPa, % mmHg

ECG ST mV, mm mV

Oxygenation Hb g/dl, g/l, mmol/l g/dl

Telemetry Alarm Delay Setup

You can set telemetry alarm delay time (6 sec by default) and ST alarm delay time (30 sec by

default). If the alarm-triggered condition disappears within the delay time, the CMS will not

give the alarm. The alarms include: HR too high, HR too low, SpO2 too high, SpO2 too low,

PR too high, PR too low, ST too high and ST too low.

Draw Waveform Type

There are two options:

 COLOR: Selecting this option allows you to see smoothed waveforms.

 MONO: Selecting this option allows you to see unprocessed waveforms.

Display Grid

You can set whether to display grid in the waveform area.

Enter the Admin Setup tab sheet

By clicking the “Admin Setup” button and inputting the required password, you can enter the

Admin Setup window. For details, refer to part 12.2 Admin Setup.

Enter the Factory Setup tab sheet

By clicking the “Factory Setup” and input the required password, you can enter the Factory

Setup window. As the “Factory Setup” is intended for use only by the

manufacturer-designated personnel, no details will be given to it in this manual.

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 189 190

Keine Kommentare

Mindray DPM 1 Betreibershandbuch Seite 146